Wisefab Nissan Skyline R34 GTT Steering Lock Drift Angle Kit
Wisefab Nissan Skyline R34 GTT Steering Lock Drift Angle Kit
£1,953.37
£1,627.81
2-3 Weeks
Finance Calculator
Finance Calculator
A loan from Omni Capital can help you spread the cost of your purchase with fixed monthly payments. Please select a deposit amount and loan term below to see a representative example of your purchase using finance.
Representative Calculation
Please note, Omni Capital Retail Finance is only available to UK residents 18 or older, subject to terms and conditions. To apply for finance, add your chosen products to your basket, proceed to checkout, and select 'Pay by Finance' as your payment method. You will be redirected to the Omni Capital website where you can complete the application online. Your purchase will be delivered to the address provided on the finance application, irrespective of what you set your order delivery address to!
Powered by Autify Digital Ltd
Description
Wisefab Nissan Skyline R34 GTT (Rear wheel drive model only)
- 65 degrees of lock, parallel steering.
You can tune your steering geometry either towards positive or negative Ackermann in just a few minutes even at trackside without messing up an alignment.
Ackermann adjustment kit included. - Adjustable lock stopper.
- One piece design.
Lower 2 piece arm is replaced with one piece design to increase system stiffness that is needed for high lock. - Higher roll center (RC).
On Wisefab Nissan R-chassis knuckle, both joints are dropped, which brings the front RC up on lowered car, providing higher roll and better camber gain. - Very good camber control and minimal bump steer with high steering angles
On drift cars the dynamic camber and bump steer is much more important than static. With Wisefab kinematics we have assured that the camber would provide very good front grip and bump steer is minimal at all the range of steering. - Steering jacking control.
During drifting, when steering angle is much bigger, jacking is also bigger, even with the same geometry and it could become a problem. We have changed the geometry so that it doesn't cause any handling issues. - Consistent and predictable self-alignment torque.
Caster is not the only important parameter to provide sufficient self-alignment torque, especially at high lock. It's the combination of different parameters to maintain consistent trail and self-alignment torque. With our setup the steering wheel turns always to the direction of movement and doesn't get stuck at full lock.
Kit includes:
- Pre-set upper and lower control arms.
- Knuckles with hardware.
- Assembled tie rods.
- Installation guide.
Other components, packaging and clearance.
- Requires S14 hubs.
- This kit assumes car to have coilovers to have enough clearance.
- Ride height is designed to be ~80mm from front subframe to ground.
- Dependent on rim width and ET, wider fenders or fender flares would be needed.
- Inner wheel wells do not need to be modified with tire diameter up to 635mm (225/45R17, 235/40R17, 235/35R18, 255/30R18 etc).
- Minimum wheel diameter is 17".
- Recommended backspacing is ~135mm (7" ET45; 8" ET35; 9" ET20). If ET is smaller, then wheels stay more outwards, if ET is bigger, then spacers need to be used.
- The kit is designed and manufactured the way that after installation and toe adjustment it's ready to use right away.
Estimate shipping for this item
Loading...
Estimate shipping for this item
Update shipping information to see available shipping methods.
,
-